K2 Bike Chubby - Manual (Page 3)

INTRODUCTION
YOUR NOLEEN
CHUBBY AND
CHUBBY LT
Congratulations! You’ve just purchased the Noleen Chubby or Chubby LT Suspension Fork! With it’s unique dual triple clamp design,
and four inches of elastomer, spring, and air travel, the Chubby is designed to let you dive into the gnarliest terrain and come out
unrattled and unscathed.
So ride the Chubby and let it Rip!
GENERAL
INFORMATION
In this section:
• Read this Manual!
• Precautions
Note: The Noleen Chubby and Chubby LT come in a Standard size (for bicycles with 90mm to 125mm head tubes) and a Long size (for
bicycles with 126mm to 160mm head tubes). Make sure that you have the correct size Chubby. If you have further questions about
the correct size, see the Installation section. Also, for any other sizing questions, please contact your K2 Bike / Noleen Dealer.
NOTE : Read this manual carefully before attempting to install or service you Chubby Fork. It is important that you follow proper
procedure to ensure maximum performance.
CAUTION: K2 Bike strongly recommends that your Chubby Fork be installed by a K2 Bike dealer or other
qualified technician. These instructions are for a qualified installer who possesses proper training and tools.
Improperly installed forks can be extremely dangerous, and can result in failure during use and severe injury.
CAUTION: The Noleen Chubby Fork is a competition off road fork, and as such does not come with reflectors
or lights for road use. Adapt proper reflectors and lights if bicycle will be used in low light conditions.
CAUTION: Installation of an incorrect length steerer tube could result in fork failure and severe injury. See
your authorized K2 Bike / Noleen dealer or other qualified technician to ensure proper installation.
CAUTION: In the event of a crash, there could be damage to your Chubby Fork that may not be visible.
Damaged forks can be extremely dangerous, and can result in failure during use and severe injuries. After a
crash, take your fork to an authorized K2 Bike/Noleen dealer or qualified technician to verify its integrity.
!
!
!
!
2