Kicker ZX300.4 - Manual (Page 4)

4
ZX AMPLIFIERS
AUTO
TURN ON
+12V DC AUDIO
OFFSET
XOVER
OFF LO LO
HI
REMOTE BASS
INPUT
SPKR + SPKR -
OUTPUT
INPUT
SENSITIVITY
OFF
ON
BASS
BOOST
GAIN L L R R
+ –
MONO OPERATION
minimum impedance of 2 ohms
signal in signal out
woofer
ZX300.1
OPERATION
AUTO
TURN ON
+12V DC AUDIO
OFFSET
XOVER
OFF LO
LO
HI
REMOTE BASS
INPUT
SPKR + SPKR -
OUTPUT
INPUT
SENSITIVITY
OFF
ON
BASS
BOOST
GAIN L L R R
Automatic Turn-On Selection: The ZX series offers three different automatic turn-on modes that can be
selected on the end panel; +12V, DC Offset, and Audio. Using either the DC Offset or Audio mode causes the
REM terminal to have +12V out for turning on additional amplifi ers.
• Remote Turn-On: Set the switch to +12V to use the remote turn-on lead from your source unit. Run 18
gauge wire from the Remote Turn-On Lead on your source unit to the terminal labeled REM between the
amplifi er’s positive and negative power terminals. This is the preferred automatic turn-on method.
• DC Offset Turn-On: If Remote Turn-On is not an option, the next best setting is DC Offset. The DC Offset
mode detects a 6V DC offset from the HI-Level speaker outputs when the source unit has been turned on.
• Signal Sense Turn-On: The Audio setting is the fi nal alternative for Automatic turn-on. This is a Signal Sense
turn-on method that detects the incoming audio signal from your source unit and automatically turns on the
amp. This turn-on method will not work properly if the input gain control is not set appropriately.
2010 ZX 300.1 400.1 500.1 750.1 RevC.indd 4 2010 ZX 300.1 400.1 500.1 750.1 RevC.indd 4 10/15/2009 10:55:55 AM 10/15/2009 10:55:55 AM