Using the multi-feed detector, Introduction, Before you begin – Kodak 923 User Manual

Page 2

Advertising
background image

A-61120 March 1999

1

Using the Multi-Feed Detector

Introduction

The

Kodak Digital Science Multi-Feed Detector aids in document

processing by detecting documents that may go through the feeder
one on top of the other. Multi-feeds can easily happen due to damp
documents, adhesives on documents, electrostatically charged
documents, or a maladjusted feeder gap.

The Multi-Feed Detector is an accessory on the following models:

•

Kodak Digital Science Scanner 9500 (S or D)

•

Kodak Digital Science Scanner/Microimager 990 (S or D)

•

Kodak Imagelink Scanners 900 and 923 (S or D)

•

Kodak Imagelink Microimager 70

For the purpose of this User’s Guide, the equipment listed above will
be generically referred to as “scanner”.

NOTE: This accessory is not intended for use on machines with the

Check Feeder accessory.

Before you begin

For the Multi-Feed Detector to function properly be sure of the
following:

•

Documents must be greater than or equal to 2.5 inches (104 mm)
in length. (Length is measured parallel to the direction of feeding.)

•

Minimum document width is 4.5 inches.

•

The thickness of the documents within a batch must be the same
within ±10% from any nominal value from 2.0 to 7.0 mils.

•

Documents should be in good condition.

•

The document stack is fanned before feeding to aid in document
separation.

•

For a microimager, be sure the Advanced Document Controller*
and skew detection is installed and enabled in the desired mode.

*

All

Kodak Digital Science

9000 series Document Scanners and

Kodak

Imagelink

900 series Scanners come with the Advanced Document

Controller installed.

Advertising
This manual is related to the following products: