Kenwood KDV-Z940 - Manual (Page 27)

— 27 —
Adjust the delay time for centre output.
Display and setting:
"CNTR DTA" : 0.0m / 0.1m / 0.3m / 0.4m / 0.6m / 0.7m / 0.9m /
1.0m / 1.2m / 1.3m / 1.5m
• You cannot operate when the “PCM Center“ is set to "OFF"
(page 29) <When playing with the 2ch PCM signal>.
• You cannot operate when the “Multi CH“ is set to “2/2“ or
“2/0“ (page 29) <When playing with multi-channels>.
NOTE
10.Delay Time for the Centre Speaker
Adjust the phase for Sub Woofer output.
Display and setting:
"SW Phase" : Normal (0°) / Reverse (180°)
You cannot operate when the “Sub Woofer“ is set to “OFF“
(page.29).
NOTE
11.Phase for Sub Woofer Output
Press the #1 - #6 button for at least two seconds.
Recalling your settings of the Crossover network/Delay time
Press the #1 - #6 button for the desired crossover network and
delay time setting.
12.Storing Your Setting of the Crossover
network/Delay time
Surround Processor Control Setting:
Adjust various parameters of sound quality.
Hold down the Q button to enter the control mode.
Selecting mode
Press either the FM or AM button.
Each time the button is pressed, the adjustment mode will
change.
Please refer to the following for the contents of the
adjustment modes.(Items 1-10 can be adjusted in this
Adjustment mode.)
Adjust each mode
Press the
4/¢ button.
Please refer to the following for the adjusting values.
Press the Q button to end the control mode.
When the Noise sequencer is turned ON, only item 10 can be
adjusted.
NOTE
4
3
2
1
You can recall the best audio setting preset for different types
of the music.
Display and Setting:
“FLAT“ / “POPS“ / “ROCK“ / “DANCE“ / “VOCAL“ /
“CLASSIC“.
• “User” displays each item when it’s adjusted.
• Not available during the Dual zone system is on.
NOTE
1.Recalling the Kenwood Preset Sound