Kawasaki 840121 - Manual (Page 7)

• Release filter bag by pulling rubber band out
around the black plastic posts.
• Pull filter bag off filter cage. Clean or discard.
• Clean area around the top of the filter cage
where filter bag will be attached. Removing
stray dust particles will ensure a tighter fit.
• Push replacement filter onto filter cage. Make
sure bag reaches all the way to the lid.
• Work your way around the filter bag, carefully
releasing the rubber band. Make sure that the
bag is held securely and that there are no gaps.
STORAGE
ALWAYS empty dust container before storage.
Wrap cord around the indentation at the bottom of
the motor housing.
Attach one end of the hose to the blower port and
the other to the vacuum port.
Store indoors in a closed box or covered with a
cloth.
STORING THE CORD
Store the power cord by wrapping it around the
indentation at the bottom of the motor housing.
ALWAYS fully uncoil power cord before use.
12
• Clean out dust container so blower will
not spray dust into the air when
activated.
• Insert hose into blower port at the rear
of Wet/Dry Vacuum/Blower.
• Plug in power cord and switch power
to ON.
• NEVER point blower hose toward
people or animals.
• Use blower to move dirt, sawdust,
leaves and other small debris away
from patios, garages and driveways.
• When blowing is completed, turn the switch off and unplug the power cord.
MAINTENANCE AND CLEANING
Before each use, make sure dust container is clean and empty. Check filter bag for
holes or tears. Clean or replace if necessary.
Wipe motor housing with mild soap and water. NEVER use solvents or harsh
chemicals.
Use warm water and mild soap to clean dust container thoroughly. Dry with soft
cloth.
DO NOT attempt to service the Wet/Dry Vacuum/Blower yourself. Take the unit to
an authorized repair technician.
CLEANING AND REPLACING FILTER
ALWAYS unplug Wet/Dry Vacuum /Blower before clean-
ing or changing the filter bag.
NEVER remove filter cage. It is there to prevent injury.
Be careful not to tear the bag when changing or cleaning the filter. NEVER use a fil-
ter bag with tears or holes in it. Torn bags will release a great deal of dust.
• Remove motor housing by pulling out on the latches located on either side of
the dust container.
• Turn motor housing upside-down and balance on top of dust container.
11
• Keep rubber band as close to the lid as
possible.
• Turn motor housing over and snap back onto
dust container.