Kawasaki 840076 - Manual (Page 4)

This metal cutting band saw is equipped with a grounded 3-wire power cord with a
3-prong plug. If the power cord will not fit into the wall plug, an approved adapter
can be used as long as it is connected to the center screw in the wall plate. Never
modify the electrical plug by cutting off the grounding prong so it will fit into unap-
proved, un-grounded electrical receptacles. See Figure 1 and the steps below to use
an AC grounding adapter:
1. Remove the cover plate mounting screw.
2. Insert the AC grounding adapter into the bottom receptacle so the green
grounding lug fits over the screw hole.
3. Install the mounting screw back into the cover plate securely attaching the
adapter to the receptacle.
If you have questions about hooking up the band saw, contact a certified electrical
contractor to install the proper circuitry acceptable for this and other power tools
you use. Repair or replace any damaged electrical wiring IMMEDIATELY.
EXTENSION CORD USAGE
Extension cords are not recommended for use with this band saw. Extension cords, if
used, must be properly grounded with a 3-prong plug on one and a 3-hole receptacle
on the other. DO NOT use grounding adapters with an extension cord. Extension
cords must be UL listed and use a minimum of 18 A.W.G. wiring. Extension cords
should never exceed 25 feet in length. Extension cords, that are too long, cause a volt-
age drop over the extra distance causing the band saw motor to run slower with the
possibility of causing damage to the motor. Using extension cords with smaller than
the recommended wire gauge run the risk of getting too hot, melting, and/or causing
fires. See table, “Extension Cord Specifications”, on page 31-32.
USE RECOMMENDED ACCESSORIES. Consult the owners manual for recommend-
ed accessories. The use of improper accessories may cause cause risk of injury.
NEVER STAND ON TOOL. Serious injury could occur if the tool is tipped or if
the cutting tool is unintentionally contacted.
CHECK DAMAGED PARTS. Before further use of the tool, a guard or other part
that is damaged should be carefully checked to determine that it will operate
properly and perform its intended function. Check for alignment of moving
parts, binding of moving parts, breakage of parts, mounting and any other con-
ditions that may affect its operation. A guard or other part that is damaged
should be properly repaired or replaced.
DIRECTION OF FEED. Only feed work into a blade or cutter against the direc-
tion of rotation of the blade or cutter.
GROUNDING INSTRUCTIONS
NEVER use appliances or equipment that has motors
with automatic reset overload protective devices. These protective devices
can cause unexpected startups that can cause property damage, severe per-
sonal injury, or death.
The electrical power source for this band saw MUST be grounded in order prevent
possible electric shock or even death should the tool malfunction or breakdown.
Grounding provides a path of least resistance for electric current thus reducing the
risk of electrical shock. The power source must also use a minimum 20A service
and not used if other power tools on the same circuit are in use.
Failure to properly ground this metal cutting band saw
could result in burns, severe electrical shock, and even death. This is espe-
cially true if used in damp or wet locations or near metallic plumbing. The
reaction from electrical shock could possibly cause your hands to make con-
tact with the cutting tools.
Not all outlets are properly grounded, regardless of the
type of receptacle they have. If you are not sure if the receptacle is properly
grounded or not, consult a certified electrician. The AC receptacle must be
protected by a dual element time delay or a circuit breaker.
6 5
FIGURE 1. CONNECTING THE BAND SAW TO THE AC POWER RECEPTACLE
UNGROUNDED AC RECEPTACLE GROUNDED RECEPTACLE
GROUNDING ADAPTER
TOOL POWER CORD
TOOL POWER CORD
COVERPLATE
MOUNTING SCREW