Kenwood DV-402 - Manual (Page 34)

34
Operations
DVF-3530 / DV-402
DVD
Dynamic Range
1 Press Cursor up/down (5/∞) keys
on the remote to select Dynamic
Range on the set up menu dis-
play, then press the ENTER key.
(Dynamic Range menu appears.)
2 Press Cursor up/down (5/∞) keys
on the remote to select Dynamic
Range mode (on or off), then press
the ENTER key.
÷ Press PLAY key to resume normal playback.
DVD
Digital Audio Out
PCM : Choose this setting for all connection
scenarios, except the Dolby Digital or
DTS receiver or decoder connection.
Dolby Digital : Choose this setting if you connected
Dolby Digital receiver or decoder to
your DVD player.
MPEG-2/DTS : Choose this setting if you connected
DTS receiver or decoder to your DVD
player
1 Press Cursor up/down (5/∞) keys
on the remote to select Digital Au-
dio Out on the set up menu dis-
play, then press the ENTER key.
(Digital Audio Out display appears.)
2 Press Cursor up/down (5/∞) keys
on the remote to select specific
Digital Audio Out mode, then
press the ENTER key.
÷ Press PLAY key to resume normal playback. DTS disclaimer clause
When playing DTS-encoded (CDs, DVDs), excessive noise
will be exhibited from the analog stereo outputs. To avoid
possible damage to the audio system, the consumer
should take proper pre-cautions when the analog stereo
outputs of the DVD player is connected to an amplifica-
tion system. To enjoy DTS Digital Surround™ playback,
an external 5.1 channel DTS Digital Surround™ decoder
system must be connected to the digital output (S/P DIF,
AES/EBU, or TosLink) of the DVD player.
Set Up functions