Kambrook CARBON KCF200 - Manual (Page 8)

8
Using Your Carbon Tower Heater
Use the screws provided to secure the
tower body to the base.
Clip the cord into the straight slot,
running from the centre to the edge
of the base. Ensure the cord is tidily
fitted into the channel, and flush with
the base.
Turn the Carbon Tower Heater back
to an upright position. It is now ready
to use.
Turning Your Heater On
Always place the heater on a firm,
level surface in a stable upright
position.
Ensure the MODE dial is turned to the
OFF position, and the TIMER dial is
turned to the 0 MINS position.
Plug the cord into a 230V or 240V
power point and switch on.
NOTE: To avoid an electrical
circuit overload, it is
recommended that no other
appliances are plugged into
the same circuit as your heater,
when it is in use.
The Power-On Indicator, on the front
of the heater, will illuminate when the
heater is turned on.
Remove any promotional material or
packaging from the heater.
Unwind the cord to its full length
and place the heater on a firm, level
surface in a stable upright position.
Visually inspect the air inlet and outlets
to ensure there are no blockages.
Assembling Your Heater
Remove all items from the packaging
- the carbon tower body, front and
rear bases. Unscrew the two screws
from the base of the tower body.
To join the front and rear bases
together, initially feed the cord
between the two parts of the base.
Position the front base over the
corresponding posts of the rear
base, and press down to fit the bases
together. Ensure the cord remains
within the channel formed when the
two halves come together.
Turn the carbon tower body upside
down. Align and position the base
over the corresponding posts on the
rear of the tower body. Push down the
base onto the tower body until it is
firmly held into position.
KCF200_IB_V4.indd 8 21/10/09 9:34 AM