Connecting the speakers, Setting up the system – Kenwood KRF-V5080D User Manual
Page 14
14
EN
CENTER
FRONT
+
-
C
R
L
RED
WHITE
GREEN
KRF-V5080D
SURROUND
+
-
R
GRAY
L
BLUE
SURROUND
BACK
SURROUND
+
-
VR-806
R
GRAY
L
BLUE
BS
BROWN
SPEAKERS (8
SPEAKERS (8-16Ω)
SPEAKERS (8-16Ω)
SUB WOOFER
PRE OUT
PRE OUT
SURR BACK
L
*
SURR BACK
R
PRE OUT
SURR BACK
L
/SURR BACK
SURR BACK
R
VR-806
*
VR-806:
SURR BACK
L
/SURR BACK
Setting up the system
Connecting the speakers
Center
Speaker
Front Speakers
Right
Left
Surround
Back Speaker
(VR-806 only)
Powered
sub woofer
Right
Left
(Be sure to connect both
surround speakers)
Surround Speakers
Surround Back Speakers
Right
Left
Surround Back Speaker
When connecting a single
Surround Back speaker
through a power amplifier to
PRE OUT jack, connect it as
above and select
“SPEAKER” at speaker
settings.
&
When connecting a Surround
Back speaker to this terminal,
select “SPEAKER” at speaker
settings.
&
To make sure that each speaker has been connected properly, pay attention to the test tone from each speaker.
Refer to “
4 Adjust the speaker volume level ”.
&
Power amplifier
Power amplifier
VR-806 only
When using both
Surround Back Left
and Right speakers,
select “PRE OUT”
at speaker settings.
&
04.1.22, 2:42 PM
14