Kenwood DV-4070 - Manual (Page 30)

Settings
30
Chapter 2: Various Setups
[Center speaker setting]
0 dB
dB
0 dB
0 ms
Speaker Setting
0 ms 0 dB 0 dB
-6 -5 -4 -3 -2 -1 0 +1 +2 +3 +4 +5 +6
ms 0 1.3 2.6 3.9 5.3
LS
R
RS
L
SW
C
C
Level
Delay Time
Exit
Off Size Normal Large
Size: Select "Normal" when the connected speaker
is incapable of reproducing audio below 100 Hz.
Select "Large" when the connected speaker can
reproduce audio below 100 Hz.
Use of center speaker: Select "Off" if the center
speaker is not used.
Level: Set the volume level.
Delay Time: Set the delay time. For the setting
value, see "Delay Time Setting".
After completing the speaker setting, select "Exit"
to enter the setting and return to the screen in
step 5.
Delay Time Setting
Ideal center speaker position
Ideal surround speaker positions
Delay time of center speaker
When playing a DVD recorded with Dolby Digital audio, the distances from the listening position to the
center and surround speakers should ideally be identical to those of all other speakers except for the
subwoofer. The delay time setting makes it possible to compensate for the difference in distances of actual
speakers by delaying the audio output from the center speaker and surround speakers so that the sounds
from all speakers reach the listening position at the same timing. (The delay time adjustment is available
only with Dolby Digital.)
Before starting the speaker setting, see the following figure and measure distance A of the center speaker
(A = Df - Dc) and distance B for the surround speakers (B = Df - Ds). The standard delay time settings can
be identified based on these values and the following tables.
LS RS
SW
C
A
B
Dc
Df
120 °
Ds
L R
30 °
¶ All speakers should be laid out within a circle
as shown in the figure.
Distance A
(A = Df - Dc)
Setting Value
Approx. 50 cm "1.3" ms
Approx. 100 cm "2.6" ms
Approx. 150 cm "3.9" ms
Approx. 200 cm "5.3" ms
¶ If distance Df is equal to or shorter than
Dc, set to "0".
Delay time of surround speakers
Distance B
(B = Df - Ds)
Setting Value
Approx. 200 cm "5.3" ms
Approx. 400 cm "10.6" ms
Approx. 600 cm "15.9" ms
¶ If distance Df is equal to or shorter than
Ds, set to "0".