Connecting wires to terminals – Kenwood DDX5022 User Manual

Page 6

Advertising
background image

6

|

DDX5022/DDX5022Y/DDX52RY

Connecting Wires to Terminals

Connector Function Guide

Pin Numbers for
ISO Connectors

Cable Colour

Functions

External Power
Connector
A-4

Yellow

Battery

A-5

Blue/White

Power Control

A-6

Orange/White

Dimmer

A-7

Red

Ignition (ACC)

A-8

Black

Earth (Ground)
Connection

Speaker
Connector
B-1

Purple

Rear Right (+)

B-2

Purple/Black

Rear Right (–)

B-3

Gray

Front Right (+)

B-4

Gray/Black

Front Right (–)

B-5

White

Front Left (+)

B-6

White/Black

Front Left (–)

B-7

Green

Rear Left (+)

B-8

Green/Black

Rear Left (–)

2WARNING
Connecting the ISO Connector

The pin arrangement for the ISO connectors depends on
the type of vehicle you drive. Make sure to make the proper
connections to prevent damage to the unit.
The default connection for the wiring harness is described in
1 below. If the ISO connector pins are set as described in 2
or

3, make the connection as illustrated.

Please be sure to reconnect the cable as shown

2 below to

install this unit to the Volkswagen vehicles etc.

1 (Default setting) The A-7 pin of the vehicle’s ISO

connector is linked with the ignition, and the A-4
pin is connected to the constant power supply.

Unit

Vehicle

A-7 Pin

A-4 Pin

Ignition cable (Red)

Battery cable (Yellow)

2 The A-7 pin of the vehicle’s ISO connector is

connected to the constant power supply, and the
A-4 pin is linked to the ignition.

Unit

Vehicle

A-7 Pin

A-4 Pin

Ignition cable

(Red)

Battery cable

(Yellow)

3 The A-4 pin of the vehicle’s ISO connector is

not connected to anything, while the A-7 pin is
connected to the constant power supply (or both
the A-7 and A-4 pins are connected to the constant
power supply).

Unit

Vehicle

A-7 Pin

A-4 Pin

Ignition cable (Red)

Battery cable (Yellow)

• When the connection is made as in

3 above, the unit’s

power will not be linked to the ignition key. For that reason,
always make sure to turn off the unit’s power when the
ignition is turned off.
To link the unit’s power to the ignition, connect the ignition
cable (ACC...red) to a power source that can be turned on
and off with the ignition key.

Advertising
This manual is related to the following products: