Kenwood HM-582MD - Manual (Page 7)

System connection
7
Knowledge section
Preparation section
Application section
Basic section
Contents
1. Connection of the System Accessories
Connect the antenna as shown in the figure.
Do not plug the power cord into a wall AC outlet until
the connection has been completed.
FM indoor antenna
The accessory antenna is for temporary indoor use only. For
stable signal reception we recommend using an outdoor
antenna. Remove the indoor antenna if you connect one
outdoors.
Connection of the Accessory Antenna
System connection
AM loop antenna
The supplied antenna is for indoor use. Place it as far as
possible from the main system, TV set, speaker cords and
power cord, and set it to a direction which provides the best
reception.
1 Plug into the terminal.
2 Locate the position providing good re-
ception condition.
3 Fix the antenna.
FM indoor antenna
FM
75 Ω
GND
AM
FM
75 Ω
GND
AM
1 2 3
AM loop antenna
FM
75 Ω
GND
AM
FM
75 Ω
GND
AM
In case of bad reception
FM outdoor antenna
(Commercially available)
Lead the 75
Ω
coaxial cable connected to the FM outdoor antenna into the room and connect it to the FM 75
Ω
terminal.
Please remove the indoor antenna after an outdoor antenna has been installed.
FM outdoor antenna
(Commercially available)
75
Ω
coaxial cable
(Commercially available)
(Commercially
available)
Assembling the antenna
Malfunction of microcomputer
If operation is not possible or errone-
ous display appears even though all
connections have been made prop-
erly, reset the microcomputer refer-
ring to “In case of difficulty”.
l