Kodak I3200 - Manual (Page 17)

A-61771 March 2013 3-1
3 Scanner Adjustments
Contents
Adjusting the input/output tray ................................................................... 3-1
Using the rear document exit ..................................................................... 3-3
Selecting your scanning application .......................................................... 3-4
Adjusting the input/
output tray
You can adjust the input and output trays to accommodate your scanning
needs.
• Adjusting the side guides — the side guides can be moved in or out to
accommodate document size. When adjusting the side guides, place your
hands on the bottom of the side guides, over the slots in the tray to slide the
guides in and out.
• Adjusting the input tray for document length — the input tray extender
has two positions. When you are scanning lettersize or A4 documents in
landscape mode, you do not need to pull out the input tray extender.
- Document lengths up to 11 inches / 27.94 cm — pull the extender out
to the first position.
- Document lengths from 11 to 17 inches / 27.94 to 43.2 cm — pull the
extender out to the full position.
- Document lengths more than 17 inches / 43.2 cm — if you are
scanning documents longer than 17 inches / 43.2 cm, the scanner driver
must be set to accommodate these long documents. Be sure to verify that
the Maximum Length option on the Device-General tab (TWAIN
Datasource) or the Longest Document option on the Scanner tab (ISIS
Driver) is set to longer than the longest document being scanned.