Kenwood KDV-412 - Manual (Page 50)

50 KDV-412
Menu
Setting security code
Sets a security code to prevent theft.
• To change/reset a security code, the security code is
required. It is recommended that you write down your
security code.
• Before setting a security code, turn off the demonstration
mode. For further information, refer to <Demonstration
setup> (page 54).
1 Set to the menu mode
Q AM SETUP AUD
VOL
MENU SCAN STOP M/S RDM REP F.SEL M.RDM
OFF
DISP PTY/C.S. SW
SRC
MENU
2 Select the security code set feature
CODE SET
3 Start security code setting
Q AM SETUP AUD
VOL
ATT
MENU SCAN STOP M/S RDM REP F.SEL M.RDM
OFF
DISP PTY/C.S.
SW
AME FM SCRL
SRC
ENTER CODE : ––––
4 Enter a security code
Select the digit to enter.
Select a number to enter.
5
Confirm the entry
Q AM SETUP AUD
VOL
ATT
MENU SCAN STOP M/S RDM REP F.SEL M.RDM
OFF
DISP PTY/C.S. SW
AME FM SCRL
SRC
RE-ENTER CODE : ––––
6 Repeat the entry
Using the same method as in the step 4, enter
the same security code.
7 Confirm the entry
Q AM SETUP AUD
VOL
ATT
MENU SCAN STOP M/S RDM REP F.SEL M.RDM
OFF
DISP PTY/C.S.
SW
AME FM SCRL
SRC
APPROVED
8 Exit the security code setting
Q AM SETUP AUD
VOL
MENU SCAN STOP M/S RDM REP F.SEL M.RDM
OFF
DISP PTY/C.S.
SW
SRC
• If the security code entered in step 6 is different from the
code entered in step 4, you must repeat the procedure
from step 4.
• Once the security code has been set, the code needs to
be entered every time the Reset button is pressed or the
battery is disconnected. For further information, refer to
<Security code entry> (page 51).
• The security code can be set in the STANDBY state. For
the basic method of how to operate the menu, refer to
<Menu setup> (page 48).
Clearing security code
Cancels the security code.
1
Set to the menu mode
Q AM SETUP AUD
VOL
MENU SCAN STOP M/S RDM REP F.SEL M.RDM
OFF
DISP PTY/C.S. SW
SRC
MENU