Kyocera Wild Card - Manual (Page 9)

User Guide 1
1 Getting started
Phone battery
Installing the battery
To install the battery:
1. Hold the phone face down
and locate the screw on the
back cover.
2. Turn the screw to set the
screw slot in vertical
position to unlock the
back cover.
3. Locate the groove on the
left side of the phone and
unsnap the hooks to
remove the back cover.
4. Place the battery in the
phone casing with the
metal contacts of the
battery touching those of
the phone.
5. Replace the back cover by
sliding the notches into the
opening on the left side.
6. Snap the back panel
into place.
7. Set the screw slot in
horizontal position to lock
the back cover.
Note: To remove the battery,
make sure the phone is powered off.
Charging the battery
You must have at least a partial charge in the
battery to make or receive calls.
To charge the battery:
Connect the AC adapter to the
jack on the bottom of the
phone. Do not force the AC
adapter into the jack. Plug the
adapter into a wall outlet.
The battery icon in the upper-right corner of the
screen tells you whether the phone is:
• Charging (animated icon)
• Partially charged
• Fully charged
Warning: The battery does not charge if you use
the phone while it is connected to an AC adapter.
Recharging the battery
You can safely recharge the battery at any time,
even if it has a partial charge.
Caring for the battery
General safety guidelines
• Do not disassemble or open the battery.
• Do not crush, bend, deform, puncture, or
shred the battery.
• Do not attempt to insert foreign objects into
the battery.
82-G1950-2EN.book Page 1 Tuesday, September 4, 2007 4:01 PM