Installation instructions, Warning, Tools and parts – KITCHENAID WINE CELLAR User Manual

Page 4: Location requirements, Electrical requirements, Unpack the wine cellar

Advertising
background image

4

INSTALLATION INSTRUCTIONS

Tools and Parts

TOOLS NEEDED:

Gather the required tools and parts before starting installation.

Location Requirements

To ensure proper ventilation for your wine cellar, allow for a

¹/₄"

(6.35 mm) space on each side and at the top. When installing
your wine cellar next to a fixed wall, leave 2

¹⁄₂" (6.35 cm)

minimum clearance on the hinge side to allow for the door to
swing open.

NOTE: It is recommended that you do not install the wine cellar
near an oven, radiator, or other heat source. Do not install in a
location where the temperature will fall below 55°F (13°C). For
best performance, do not install the wine cellar behind a cabinet
door or block the base grille.

Electrical Requirements

Before you move your wine cellar into its final location, it is
important to make sure you have the proper electrical
connection.

Recommended grounding method

A 115 Volt, 60 Hz., AC only, 15– or 20–amp fused, grounded
electrical supply is required. It is recommended that a separate
circuit serving only your wine cellar be provided. Use an outlet
that cannot be turned off by a switch. Do not use an
extension cord.

NOTE: Before performing any type of installation, cleaning, or
removing a light bulb, unplug wine cellar or disconnect power.

Unpack the Wine Cellar

Remove the Packaging

Remove tape and glue residue from surfaces before turning
on the wine cellar. Rub a small amount of liquid dish soap
over the adhesive with your fingers. Wipe with warm water
and dry.

Do not use sharp instruments, rubbing alcohol, flammable
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your wine cellar. For
more information, see “Wine Cellar Safety.”

Phillips screwdriver

WARNING

Explosion Hazard

Keep flammable materials and vapors, such as
gasoline, away from wine cellar.

Failure to do so can result in death, explosion, or fire.

2

¹⁄₂

" (6.35 cm)

¹⁄₄

" (6.35 mm)

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death,
fire, or electrical shock.

WARNING

WARNING

Excessive Weight Hazard

Use two or more people to move and install wine cellar.

Failure to do so can result in back or other injury.

Advertising