Kenwood VR-5090 - Manual (Page 64)

56
Using R
eceiv
er
Operation using the SYS.POWER button on Remote Control unit
To perform the Multi-Zone operation, switch the Multi Zone function
On in advance (see page 55).
1. When the receiver is OFF (STANDBY mode):
• To output the video and audio to Zone A, set the Zone setting of
the remote to Zone A then press the SYS.POWER button on the
remote.
• To output the video and audio to Zone B, set the Zone setting of
the remote to Zone B then press the SYS.POWER button on the
remote.
2. When the video and audio are output to Zone A only:
• To turn the receiver OFF (STANDBY mode), set the Zone setting
of the remote to Zone A then press the SYS.POWER button on the
remote.
• To output the video and audio to Zone B, set the Zone setting of
the remote to Zone B then press the SYS.POWER button on the
remote.
3. When the video and audio are output to Zone B only:
• To turn the receiver OFF (STANDBY mode), set the Zone setting
of the remote to Zone B then press the SYS.POWER button on the
remote.
• To output the video and audio to Zone A, set the Zone setting of
the remote to Zone A then press the SYS.POWER button on the
remote.
4. When the video and audio are output to both Zone A and Zone B:
• To turn the receiver OFF (STANDBY mode), set the Zone setting
of the remote to Zone A then press the SYS.POWER button on the
remote.
• To defeat the video and audio outputs to Zone B, set the Zone
setting of the remote to Zone B then press the SYS.POWER button
on the remote.
The receiver can also be turned OFF (STANDBY mode) by pressing the
POWER button on the receiver.
Using Remote Control Unit in Multiple Zones