KITCHENAID Bottom-Mount Built-In Refrigerator - Manual (Page 8)

8
If the water pressure to the reverse osmosis system is less than
40 to 60 psi (276 to 414 kPa):
■ Check to see whether the sediment filter in the reverse
osmosis system is blocked. Replace the filter if necessary.
■ Allow the storage tank on the reverse osmosis system to refill
after heavy usage.
■ If your refrigerator has a water filter cartridge, it may further
reduce the water pressure when used in conjunction with a
reverse osmosis system. Remove the water filter cartridge.
If you have questions about your water pressure, call a licensed,
qualified plumber.
Tipping Radius
Be sure there is adequate ceiling height to stand the refrigerator
upright when it is moved into place.
■ The dolly wheel height must be added to the tipping radius
when a dolly is used.
■ If needed, the tipping radius can be reduced. See “Reduce
Tipping Radius.”
Side Tipping Radius (36" [91.4 cm] Models)
Side Tipping Radius (42" [106.7 cm] Models)
Product Dimensions
Side View
■ The depth from the front of the top grille to the back of the
refrigerator cabinet is 25
³⁄₈" (64.5 cm).
■ The power cord is 84" (213 cm) long.
■ The water line attached to the back of the refrigerator is 5 ft
(1.5 m) long. Height dimensions are shown with leveling legs
extended
¹⁄₈" (3 mm) below the rollers.
*When leveling legs are fully extended to 1 ¹⁄₄" (3.2 cm) below
rollers, add 1
¹⁄₈" (2.9 cm) to the height dimensions.
Top View
36" (91.4 cm) Models
42" (106.7 cm) Models
A. Tip this side only
A. Tip this side only
90
¹⁄₂
"
(229.9 cm)
A
93"
(236.2 cm)
A
25
³⁄₈
"
(64.5 cm)
23
¹⁄₂
"
(59.7 cm)
84" (213.4 cm)
Power Cord
*83
³⁄₈
"
(211.8 cm)
*3
¹⁄₂
" (8.9 cm)
25
³⁄₈
"
(64.5 cm)
35
¹⁄₄
"
(89.5 cm)
25
³⁄₈
"
(64.5 cm)
4 1 ¹⁄₄
"
(105 cm)