Kawasaki KFX T4872 - Manual (Page 9)

9 P9723b-0920
Wrench
3 /
8
" -16 Hex Nut
2
• Position the vehicle upside down.
• Slide the rear axle assembly through the hole in the back end
of the vehicle, as shown. Make sure the rear wheel driver fits
into the pins in the motor assembly inside the vehicle.
3
• Slide a rear wheel driver, slotted side out, onto the rear axle.
Make sure the rear wheel driver fits into the pins in the motor
assembly inside the vehicle.
• Locate the other rear wheel. Slide the wheel, flat side first,
onto the rear axle. Make sure the slots on the rear wheel
driver fit onto the pegs on the wheel.
• Slide a wheel cover, indented side out, onto the rear axle.
• Fit a 3 /
8
" -16 hex nut onto the end of the rear wheel assembly.
• Completely tighten the hex nut on the rear wheel assembly
with the wrench.
Hint: An extra wrench has been provided to hold the hex nut
on the other side of the rear axle while tightening the hex nut
on the other side.
You may need the help of another adult to hold the vehicle •
while you tighten the hex nut.
4
Rear Axle Assembly
BOTTOM VIEW
Motor Assembly
Rear Wheel
(Pegged Side First)
Rear Wheel Driver
(Slotted Side Out)
Wheel Cover
(Indented Side Out)
Motor Assembly
Steering Column
Connector
BACK VIEW
• Turn the vehicle upright.
• Fit the handlebar steering column down through the large
opening in the front end of the vehicle.
5