KRK 10S - Manual (Page 9)

Audio Input
10k Ohms Balanced
Pin 2 + Tip = High
Pin 3 + Ring = Low Pin
1 + Sleeve = Ground
Connecting Your System
IMPORTANT: All connections should be made, all fader and
controls should be set at their minimum levels, and all other
equipment should be powered prior to powering up your
KRK10s subwoofer. If you are connecting the sub’s Line Outs to
your monitors, turn monitor power on after the subwoofer.
NOTE: Ensure that the voltage indicator found in the voltage selector is
set to the correct voltage setting for your local supply.
Powering On
The power On/Off switch is located on the rear panel. The triangle in the
KRK logo on the rear plate illuminates when power is applied.
Changing Voltage
To change the voltage, remove the power cord and slide the voltage
selector to the desired voltage setting. Please note that when making
voltage changes, the fuses will have to be replaced (refer to the
Changing Fuses section below).
Changing Fuses
Under normal operation the fuses should not blow. A blown fuse
usually indicates an overload or fault condition. To change the fuse,
remove the power cord, pry off the fuse block with a small flathead
screwdriver and change the blown fuses. Refer to the Specifications
section for fuse current ratings.
NOTE: If the fuses blow immediately upon power up, this indicates a
fault condition and the monitor should be returned to KRK for repair.
Audio Inputs
The XLR and TRS are +4 dBu balanced inputs whereas the RCA inputs
are -10 dBu unbalanced.
ON
OFF
Unbalanced
XLR
Connectors
TRS 1/4”
Connectors
RCA Inputs
Balanced
6