Kenwood DPX304 - Manual (Page 46)

46
| DPX504U/ DPX404U/ DPX304
Clock and Other Functions
Resetting the Security Code function when the
audio unit is first used after removed from the
battery power source or the Reset button is
pressed.
1
Turn the power ON.
2
Do the step 5 through 8 operation, and enter
the Security Code.
“Approved”/ “APPROVED” is displayed.
Now, you can use the unit.
⁄
• To deactivate the Security Code function, see the next
section
<Deactivating Security Code> (page 47) .
Activating Security Code
When Security Code is set, possibility of theft
is reduced because input of Security Code is
prompted to turn on the unit once it is turned off.
⁄
• You can set the Security Code with a 4 digit number of your
choice.
• The Security Code cannot be displayed or referenced. Make
a note of the Security Code and treasure it up.
1
Select the Standby
Press the [SRC] button.
Select the “STDBY”/ “STANDBY” display.
2
Enter Function setting mode
Press the [VOL] knob.
3
Select Security Code mode
Turn the [VOL] knob and press it when the
desired item is displayed.
Select “Initial Settings”/ “INITIAL SET”
>
“Security Set”/ “SECURITY SET”
4
Enter Security Code mode
Press the [VOL] knob for at least 1 second.
When “Enter”/ “ENTER” is displayed, “[–][–][–][–]”/
“CODE” is also displayed.
5
Select the digits to enter
Press the [
4] or [¢] button.
6
Select the Security Code numbers
Turn the [VOL] knob.
7
Repeat steps 5 and 6, and complete the
Security Code.
8
Confirm the Security Code
Press the [VOL] knob for at least 3 seconds.
When “Re-Enter”/ “RE-ENTER” is displayed, “[–][–][–]
[–]”/ “CODE” is also displayed.
9
Do the step 5 through 8 operation, and reenter
the Security Code.
“Approved”/ “APPROVED” is displayed.
The Security Code function activates.
⁄
• If you enter the wrong Code in steps 5 through 7, repeat
from step 4.
10
Exit Function setting mode
Press the [ ] button for at least 1 second.