Troubleshooting guide, General, Tuner source – Kenwood DPX304 User Manual

Page 74: Disc source, Audio file source

Advertising
background image

74

|

DPX504U/ DPX404U/ DPX304

Troubleshooting Guide

Some functions of this unit may be disabled by
some settings made on this unit.

!

• Cannot set up the subwoofer.

• No output from the subwoofer.

• Cannot set up the subwoofer position of Manual

position setting.

▲

• The Dual zone function is enabled.

<Dual Zone

System> (page 51)

•

“SubWoofer”

of

<Audio Control> (page 48)

/

“SUBWOOFER SET”

of

<Audio Control> (page 52)

is

not set to ON.

•

“SubWoofer”

>

“FC”

of

<X’Over Setting> (page 56)

/

“LPF SUBWOOFER”

of

<Audio Control> (page 52)

is

set to “Through”/ “THROUGH”.

• In the speaker select option, None is selected for

the subwoofer.

<Speaker Setting> (page 54)

!

• Cannot set up the equalizer.

• Cannot set up the Bass Boost.

• Cannot set up the Highway sound.

• Cannot set up the Supreme.

• Cannot set up the Position control.

▲

• The Dual zone function is enabled.

<Dual Zone

System> (page 51)

• The DSP function is disabled.

“DSP Set” of

<Audio

Control> (page 48)

• In the speaker select option, None is selected for

the rear speakers.

<Speaker Setting> (page 54)

!

• Cannot select the output destination of the

subsource in the Dual zone.

• Cannot adjust the volume of the rear speakers.

▲

The Dual zone function is disabled.

<Dual Zone

System> (page 51)

!

Cannot set up Display.

▲

<Demonstration mode Setting> (page 45)

is not

turned off.

!

Cannot switch to USB/iPod source.

▲

The Dual zone function is set to USB/iPod.

<Dual

Zone System> (page 51)

!

The number of songs contained in “SONGS”

category of this unit is different from that

contained in “SONGS” category of iPod.

▲

Podcast files are not counted in this unit as this unit

does not support the playback of podcast files.

What might seem to be a malfunction in your unit
may just be the result of slight misoperation or
miswiring. Before calling service, first check the
following table for possible problems.

General

?

The operation check sound (beep sound) does not

sound.

✔

The preout jack is being used.

The Touch Sensor Tone cannot be output from

the preout jack.

?

The illumination flashes when the knob or button

is operated.

✔

This is the key illumination effect.

You set this effect in “ILLUMI Effect” of

<Display

Setting> (page 36)

.

?

The key illumination effect brought about in

conjunction with the sound volume is small.

✔

The key illumination effect may be insufficient

depending on the sound volume and sound quality.

Tuner source

?

Radio reception is poor.

✔

The car antenna is not extended.

Connect the Antenna control wire to the power

terminal for the booster amplifier of the film-type
or short pole type antenna
Pull the antenna out all the way.

Disc source

?

The specified disc does not play, but another one

plays instead.

✔

The specified CD is quite dirty.

Clean the CD, referring to the CD cleaning of the

section on

<Handling discs> (page 4)

.

✔

The disc is loaded in a different slot from that

specified.

Eject the disc magazine and check the number

for the specified disc.

✔

The disc is severely scratched.

Try another disc instead.

Audio file source

?

The sound skips when an Audio file is being

played.

✔

The media is scratched or dirty.

Clean the media, referring to the CD cleaning of
the section on

<Handling discs> (page 4)

.

✔

The recording condition is bad.

Record the media again or use another media.

Advertising
This manual is related to the following products: