KORG MR-2000S - Manual (Page 30)

30
2. Turn the dial to select the desired value, and press the
enter button to complete the setting.
The selection icon will change from " " to " ."
Mark mode setting (Mark Mode)
Here you can specify the mark mode that will be used during
recording. This setting does not affect the marks that you reg-
ister during playback.
New Mark: Marks will be added in the conventional way
Divide: The file will be divided where each mark is added
( → p.35)
1. In the system setting (SYSTEM) screen, use the dial to
select "Mark Mode" and then press the enter button to
confirm.
The mark mode (Mark List) setting screen will appear.
2. Use the dial to select the desired mode, and press the
enter button to confirm.
A check mark will appear in the check box for the mark
mode you selected and confirmed.
3. When you've finished adjusting the settings, press the
exit button to return to the system setting (SYSTEM)
screen.
Device information (Device Info)
Here you can view the version of the MR-2000S's system soft-
ware, the total capacity of the hard disk, the free capacity, and
the number of recorded projects/files.
1. In the system setting (SYSTEM) screen, use the dial to
select "Device Info" and press the enter button to con-
firm.
The information (Device Information) screen will appear.
2. When you've finished viewing the information, press
the enter button to return to the system setting (SYS-
TEM) screen.
DSD output fillter settings (DSD Filter)
If you turn this setting on, a 1-bit project/file will pass
through the signal processing filter during playback. By
default, this is "ON". The icon for the settings will appear in
the home screen (p.11).
ON ( ) : Playback will pass through the DSD filter (-3.0
dB at the pass frequency of 50 kHz).
OFF :The 1-bit signal will play back directly without going
through the DSD filter.
This setting can be made only while the unit is stopped.
Noise or extraneous sound may occur if you connect your
MR-2000S to a device that does not support wideband audio
input. Before turning this setting off, you must check the
owner's manual of the connected device.
1. In the system setting (SYSTEM) screen, use the dial to
select "DSD Filter" and press the enter button to con-
firm.
The selection icon will change from " " to " ", and the
value will be highlighted.
2. Press the enter button to complete the setting.
The selection icon will change from " " to " ".