Kambrook JAGUAR TWISTER KBV50 - Manual (Page 5)


KAMBROOK SAFETY
READ ALL INSTRUCTIONS BEFORE
OPERATING AND SAVE FOR FUTURE
REFERENCE
USING YOUR KAMBROOK JAGUAR
TWISTER VACUUM CLEANER
When unpacking the vacuum cleaner check to see
you have received all the required components,
such as the hose and other accessories before
discarding the packaging.
Ensure that the dust container and filters are
correctly fitted.
Locate the crush proof hose (KBV50 only)/telescopic
hose (KBV580 only) and push the connection on the
front side of the unit, until a “click” sound is heard.
Connect the wide end of the metal wand to the
hose end, and push together firmly.
Fit the floor tool to the narrow end of the wand and
push together firmly.
Fully extend the power cord by pulling the power
plug out from rear of the vacuum, until the yellow
tape on the cord is showning.
 IMPORTANT: ENSURE THAT YOU DO NOT OVER EXTEND THE
POWER CORD - DO NOT EXTEND PAST THE RED WARNING TAPE
ON THE CORD.
Plug into a 230/240V power point and switch the
power on.
To commence vacuuming push down on the on/off
button
on/off cord
press
& lift
up down
at the top of the vacuum.
When vacuuming is complete, push down on the
‘on/off’ button to switch off. Turn the power off at
the outlet and then remove the power cord from
the power outlet. When removing the plug from the
power outlet, grasp the plug not the cord.
To retract the cord push down on the ‘cord rewind
button’
on/off cord
press
& lift
up down
to retract the cord.
 IMPORTANT: HOLD THE PLUG END WHEN RETRACTING THE
CORD TO PREVENT IT FROM STRIKING YOU OR THE VACUUM.
 IMPORTANT: ALWAYS ENSURE THAT THE DUST CONTAINER
AND THE MOTOR PROTECTION FILTER ARE CORRECTLY FITTED.
NEVER OPERATE WITHOUT THE DUST CONTAINER OR FILTERS
IN PLACE.
VARIABLE POWER CONTROL
The power booster dial on the unit is to be used for
variable power control. Turn the control clockwise
for maximum power for vacuuming hard floor and
carpet surfaces. Turn the control anti-clockwise for
minimum power when using the crevice and brush
tools.
CREVICE AND BRUSH TOOL
ACCESSORIES
The crevice tool is ideal for vacuuming hard to
reach places such as the edges along skirting
boards.
The brush and upholstery tools can be used to
vacuum delicate surfaces and areas such as
shelves and venetian blinds.
Set the variable speed control between minimum
and medium power when using the tool
accessories.
Turn off the vacuum cleaner when changing any
attachments.
KBV580_IB_V3.indd 5 10/6/09 3:21:47 PM