Kenwood X1200M - Manual (Page 5)

English

P.CON SPEAKER OUTPUT
REMOTE
GND BATT.
LINE IN LINE OUT
L
R
P.CON SPEAKER OUTPUT
REMOTE
GND BATT.
LINE IN LINE OUT
L
R
P.CON SPEAKER OUTPUT
REMOTE
GND BATT.
LINE IN LINE OUT
L
R
FUSE [30Ax3]
FUSE [30Ax3]
FUSE [30Ax3]
INPUT
SENSITIVITY[V]
0.2 [MAX]
0.3
0.5
1
2
3
4
[MIN] 5
LINE OUT
FILTER
ON
OFF
INPUT
SENSITIVITY[V]
0.2 [MAX]
0.3
0.5
1
2
3
4
[MIN] 5
LINE OUT
FILTER
ON
OFF
INPUT
SENSITIVITY[V]
0.2 [MAX]
0.3
0.5
1
2
3
4
[MIN] 5
LINE OUT
FILTER
ON
OFF
Remote cable
Remote controller
CENTER UNIT
(CD receiver, etc.)
You can control the Bass boost level of the
second and subsequent Slave amplifiers
simultaneously from the Master amplifier.
The volume level of each amplifier is
determined by the setting of the Master
amplifier (INPUT SENSITIVITY, boost level of
the remote controller).
Setting the Master amplifier
1. Adjust the INPUT SENSIVITY to the output
of the center unit to be connected.
2. Set the LPF frequency and ISF.
3. Turn the LINE OUT FILTER switch ON.
Setting the Slave amplifier
1. Turn the LINE OUT FILTER switch OFF.
2. Adjust the INPUT SENSIVITY.
• To adjust the Slave amplifier to the same
volume as the Master amplifier, adjust the
INPUT SENSIVITY to 0.2 V (max.).
CAUTION
• Before connecting the remote controller
cables, always turn the Bass boost level
knob all the way to the left.
* Commercially available parts
■ Multi Amplifier with Remote cable connection (Optional accessory)
CAUTION
• Before connecting the remote controller
cables, always turn the Bass boost level knob
all the way to the left.
Master amplifier
Slave amplifier
Slave amplifier
Power control wire*
Extension wire*
RCA cable*
RCA cable*
Remote cable (6.0 m : 19.7 ft)
Remote controller
■ Remote cable connection (Optional accessory)
P.CON SPEAKER OUTPUT
REMOTE
FUSE [30Ax3]
GND BATT.
LINE IN LINE OUT
L
R
Use the
attached
Hexagon
Wrench.
Hexagon Wrench
(Small)
X1200M_K_1English.indd 5 08.10.21 1:32:24 PM