Kenwood VR-8050 - Manual (Page 30)

30 EN
Ambience effects
Convenient functions
MULTI CONTROL DIMMER STEREO
SOUND LISTEN MODE
Sound
Listen Mode 5/ ∞
Stereo
(Multi %/ fi,
@ / #)
Dimmer
TUNER
Adjusting the sound
You can make further adjustments to the sound while listening to
playback in the surround mode.
1 For the remote control, press and hold the TUNER key for
more than 3 seconds to switch to receiver mode.
2 Press the SOUND key and then use the ∧∧∧∧∧/∨∨∨∨∨ keys or @/# keys until
the desired item appears in the display.
Each time you press the ∧ ∧ ∧ ∧ ∧/∨ ∨ ∨ ∨ ∨ keys or @/# keys, the menu changes
as follows:
Note that some items are not displayed depending on speaker
settings and listening modes.
1 CNTR (Center speaker level adjustment)*
2 SR (Surround Right speaker level adjustment)*
3 SBR (Surround Back Right speaker level adjustment)*
4 SBL (Surround Back Left speaker level adjustment)*
5 SL (Surround Left speaker level adjustment)*
6 SUBW (Subwoofer level adjustment)*
7 INPUT (Input level adjustment - analog mode only)
(
8 MIDNIGHT (Midnight mode ON/OFF - Dolby Digital and DTS
mode only)
9 PANORAMA (Panorama mode ON/OFF)**
0 DIMENSION (Dimension adjustment)**
- CENTER WIDTH (Center width adjustment)**
= DUAL MONO (Dual Mono selection - Dolby Digital mode only)
* The adjustment is only temporary for the current input selection.
The value will return automatically to the original setup value when
the power is turned on/off or when the input selection is changed.
** Pro Logic IIx and Pro Logic II Music mode only.
• If you have selected “SB/SW AMP SB”, “SBR” and “SBL” are
not appeared but “SB” is appeared on the Display.
3 Use the MULTI CONTROL knob or Multi (%/fi) keys to adjust the
setting as desired.
• The adjustment item is displayed for approximately 20 seconds.
DVD 6-channel playback
Using a DVD player or the like equipped with six (5.1) output channels and
the receiver, you can enjoy surround sound playback.
Connecting a DVD player which can decode the surround signal itself is
also acceptable.
INPUT MODE
DVD/6CH
Input Mode
VOLUME
CONTROL
DVD/6CH
VOL /
Preparations
• Connect your DVD player to the DVD/6CH jacks of the receiver.
• Turn on all other components that will be used.
• Complete “Preparing for surround sound”.
&
1
Press “DVD/6CH” as the input source.
• If speaker system B is on when “DVD/6CH” is selected as the input
source, it switches off and speaker system A turns on automatically.
2
Select "6CH INPUT" by pressing the INPUT MODE key.
3
Start playback of the DVD software.
4
Adjust the volume.
• It is not possible to adjust the volume level or sound quality (SET
UP, SOUND, LISTEN MODE, ACTIVE EQ, SPEAKER EQ, STE-
REO, DSP, LOUDNESS and TONE key will not be functional) of
the channels separately when the receiver is in the 6CH INPUT
mode. Adjust the volume with the controls of the DVD player.
For the powered subwoofer, you can adjust the volume of the
subwoofer using the subwoofer’s own volume control.
04.3.5, 11:06 AM 30