Kenwood VR-505 - Manual (Page 21)

21
Operations
Normal playback
1
Listening to a source component
Use the INPUT SELECTOR knob to select the source you
want to listen to.
The input sources change as shown below:
Selecting a source using the INPUT SELECTOR knob.
Adjusting the tone
You can adjust the sound quality when the receiver is in the PCM stereo
and analog stereo mode.
1 Press the SOUND key to select the tone mode to be adjusted.
• The bass and treble levels are adjustable from -10dB to +10dB in 2
step increments.
• The adjustment item is displayed for approximately 8 seconds.
2 Use the MULTI CONTROL keys to adjust the sound quality.
BASS: Select this to adjust the low frequency range.
(Press the SOUND key once.)
TREB: Select this to adjust the high frequency range.
(Press the SOUND key twice.)
FM
AM
MHz
kHz
PRO LOGIC
3
DOWN MIX
DIGITAL
S.DIRECT
MONITOR
DSP
MEMO
ST.
TUNED
AUTO SOUND AUTO
LFE
C
S RS LS
TI.VOL B
CLIP MUTE
RDS EON PTY
TP TA NEWS
SW
L SP A R
STEREO
Once-touch low frequency emphasis (bass boost)
(remote control only)
You can adjust the sound quality when the receiver is in the PCM stereo
and analog stereo modes.
Press the B. BOOST (BASS BOOST) key.
• Press the key once to select the maximum (+10dB) low frequency
emphasis setting.
• This key does not function when the receiver is in the sound quality or
ambience effects adjustment mode.
Switching back to the previous setting
Press the B. BOOST (BASS BOOST) key again.
2
3
Start playback from the selected source.
Use the VOLUME CONTROL knob (VOLUME keys) to adjust
the volume.
Selecting VIDEO 2/MONITOR
Depending on the component connected to the VIDEO 2/MONITOR
jacks, select either the “ VIDEO 2” setting or the “MONITOR” setting, as
appropriate.
Adjusting the sound
KRF-V5050D
1 “PHONO”
2 “TUNER”
3 “CD/DVD”
4 “TAPE” or “MD”
5 “VIDEO1”
if VIDEO2/MONITOR is VIDEO2
6 “VIDEO2”
7 “DVD/6ch”
else if VIDEO2/MONITOR is MONITOR
6 “DVD/6ch”
VR-517/KRF-V5550D
1 “AUX”
2 “TUNER”
3 “CD/DVD”
4 “TAPE” or “MD”
5 “VIDEO1”
if VIDEO2/MONITOR is VIDEO2
6 “VIDEO2”
7 “DVD/6ch”
8 “AV AUX” (VR-517 only)
else if VIDEO2/MONITOR is MONITOR
6 “DVD/6ch”
7 “AV AUX” (VR-517 only)
VR-506/KRF-V6050D
1 “PHONO”
2 “TUNER”
3 “CD/DVD”
4 “TAPE” or “MD”
5 “VIDEO1”
if VIDEO2/MONITOR is VIDEO2
6 “VIDEO2”
7 “DVD/6ch”
8 “AV AUX”
else if VIDEO2/MONITOR is MONITOR
6 “DVD/6ch”
7 “AV AUX”
RC-R0511
INPUT
SELECTOR
INPUT SELECTOR
VOLUME CONTROL
VOLUME
RC-R0615/R0617
SOUND
VOLUME CONTROL
SOURCE DIRECT
PHONES
SPEAKERS A/B
(SPEAKER/MUTE)
MULTI CONTROL
MUTE
BASS BOOST/
B. BOOST
MULTI
CONTROL
RC-R0615/R0617
SOUND
RC-R0511
VOLUME
9
VR-505
1 “AUX”
2 “TUNER”
3 “CD/DVD”
4 “TAPE” or “MD”
5 “VIDEO1”
if VIDEO2/MONITOR is VIDEO2
6 “VIDEO2”
7 “DVD”
else if VIDEO2/MONITOR is MONITOR
6 “DVD”
_4942/20-22/EN 3/16/01, 3:07 PM 21