KITCHENAID KIDS01EK - Manual (Page 12)

12
Changing a Cycle or Setting
During the first fill of a cycle
1. Open the lid.
2. Press a new cycle and/or options.
3. Check the detergent. Dishwasher must contain the proper
amount for the new cycle.
4. Close and latch the lid. The dishwasher resumes the new
cycle and/or option after a 5-second pause.
After the first fill of a cycle
1. Open the lid.
2. Press the Cancel pad.
3. Close the lid. Your dishwasher starts a drain. Let the
dishwasher drain completely.
4. Open the lid.
5. Select a new cycle and/or options.
6. Check the detergent. Dishwasher must contain the proper
amount for the new cycle.
7. Press the Start pad.
8. Close and latch the lid.
Adding Items During a Cycle
You can add an item anytime before the main wash starts. Open
the lid and check the detergent amount. If the detergent is still
visible, you can add items.
To add items
1. Turn the knob latch to stop the cycle. Wait for the spraying
action to stop before opening the lid completely.
2. Open the lid. If the detergent is still visible in the wash water,
you may add the item.
3. Close the lid firmly and turn knob to latch. The dishwasher
resumes the cycle after about a 5-second pause.
Option Selections
You can customize your cycles by pressing the SANI RINSE™
option. If you change your mind, press the option again to turn
the option off.
You can change an option anytime before the selected option
begins.
Press the Start pad to repeat the same cycle and option as the
previous wash cycle.
NOTE: If the last cycle you completed was a rinse cycle, when
you press the Start pad, the dishwasher runs the last full wash
cycle and option.
SANI RINSE™ Option
Select this option to raise the water temperature in the final rinse
to approximately 160°F (71°C). The SANI RINSE™ option adds
heat and time to the cycle.
NOTE: SANI RINSE™ is an option with the Pots/Pans, Normal,
and Quick Wash cycles.
Control Lock
Use Control Lock to prevent unintended use of the dishwasher.
You can also use the control lock feature to prevent unintended
cycle or option changes during a cycle.
When Control Lock is lit, all buttons are disabled.
NOTES:
■ The dishwasher lid can be opened while the controls are
locked.
■ You can turn on the lock while the dishwasher is running.
To turn on the lock
Press and hold
for 4 seconds. Control Lock glows.
If you press any pad while your dishwasher control is locked, the
light flashes 3 times.
To turn off the Lock
Press and hold SANI RINSE™ option control for 4 seconds. The
light turns off.