KITCHENAID ARCHITECT KERS308X - Manual (Page 30)

30
Care & Cleaning
Do not use the following on the cooktop:
• Do not use abrasive cleaners and scouring pads, such as
metal and some nylon pads. They may scratch the
cooktop, making it more difficult to clean.
• Do not use harsh cleaners, such as chlorine bleach,
ammonia or oven cleaners, as they may etch or discolor
the cooktop.
• Do not use dirty sponges, cloths or paper towels, as they
can leave soil or lint on the cooktop which can burn and
cause discoloration.
Important note:
Damage to the ceramic glass cooktop may occur if you
use an abrasive type cleaning pad. Only use cleaning
products that have been specifically designed for ceramic
glass cooktops.
Cooktop cleaning
The oven light is located at
the rear of the oven cavity
and is covered with a glass
shield held by a wire
holder. The glass shield
protects the light bulb and
must be in place whenever
the oven is in use.
To replace interior
oven light bulb:
1. Turn electrical power off
at the main source or
unplug the range.
glass
shield
2. Press wire holder to one side to release the glass shield
that covers the light bulb.
3. Replace light with a new 40 watt appliance bulb.
4. Replace glass shield over bulb and snap wire holder
back into place.
5. Turn power on at main source (or plug the appliance in).
6. The clock will then need to be reset. To reset, see
Setting clock in this Use & Care Guide.
Aluminum foil and utensils
NEVER cover any slots, holes or
passages in the oven bottom or cover an entire oven
rack with materials such as aluminum foil. Aluminum
foil linings may trap heat, causing a fire hazard.
Protective Liners — DO NOT USE
ALUMINUM FOIL to line the oven bottom. Only use
aluminum foil as recommended in this manual. Improper
installation of these liners may result in risk of electric
shock, or fire.
• Aluminum foil - Use of aluminum foil on a hot cooktop
can damage the cooktop. Do not use thin aluminum
cooking utensils or allow aluminum foil to touch the
surface elements under ANY circumstances.
• Aluminum utensils - The melting point of aluminum is
much lower than that of other metals. Care must be
taken when aluminum pots or pans are used on the
cooktop. If aluminum pans are allowed to boil dry when
using the cooktop, not only will the utensil be damaged
or destroyed, but it may fuse to, break or mark the
ceramic glass surface, permanently damaging the
cooktop surface.
Replacing oven light
Be sure the range is unplugged and all
parts are COOL before replacing oven light. Wear a
leather-faced glove for protection against possible broken
glass.
General cleaning
Refer to the Cleaning recommendation table in the Care &
Cleaning section for more detailed information about
cleaning specific parts of the range.
Before manually cleaning any part of
the range, be sure all controls are turned OFF and the
range is COOL. The range may be hot and can cause
burns.
Ammonia must be rinsed before
operating the oven. Provide adequate ventilation.
wire
holder