Kompernass PTBM 350-13 - Manual (Page 4)

ƽ
BENCH DRILL PTBM 350-13
For drilling in wood, plastic and metal
Please read carefully through the following information concerning safety and proper use.
Before reading, fold out the page with the illustrations and make yourself familiar with all the
functions of the equipment. Please read the operating instructions below and the
accompanying safety advice carefully. Use the equipment only as described and for the
indicated purposes. By doing this you will be able to work in complete safety and produce
better results.
Be careful to keep these advice notes and if necessary pass them on to a third party.
PROPER USE
The bench drill is intended for drilling in wood, plastic and metal using normal drill bits
up to a maximum diameter (ø) of 13 mm. Any other use of or modification to the
machine shall be considered as improper use and could give rise to serious danger.
SPECIFIC SAFETY ADVICE
̅ In addition, you must also read the advice in the accompanying booklet called "Safety advice"
before using the equipment for the first time.
̅ When you are using the bench drill always wear ear protectors and protective
glasses. We recommend that you wear robust anti–slip footwear, a working
apron or close-fitting clothing, If you have long hair you should wear some sort of hair protection
(such as a hair net, cap or headscarf) to ensure that your hair does not become trapped in moving
machine parts or twisted about the drill bit or chuck. Do not wear gloves when drilling.
̅ Do not remove any mechanical or electrical safety devices.
̅ Always check that all safety devices are attached and properly fixed in place.
̅ Always check that the workpiece is firmly and securely clamped in place.
̅ Never drill a workpiece whilst holding it in your hands.
̅ Check that the chuck is properly attached.
̅ Never clean or lubricate the bench drill when it is in motion.
̅ Before adjusting, maintaining or repairing the drill, always remove the plug from the mains socket.
̅ Use a hand brush to remove drilling swarf.
̅ Ensure that you work safely by firmly fixing down the machine on to a working surface.
̅ Always keep the drive/ belt cover closed to keep hands and fingers out.
̅ Always use the key to open or close the drill chuck.
FEATURES OF THE PTBM 350-13
³ Base plate
· 3 column/base fixing screws
» Drilling table
¿ 4 drill vice screws
´ Drill vice
² Column
¶ Motor unit
º On/off switch
Ꮯ ƭ Ư
4