Kobe Range Hoods CH0030SQB (30") - Manual (Page 15)

12
OPERATING INSTRUCTIONS
This KOBE hood is equipped with four electronic controls with a 10-second standby startup & 30-
second delay shutoff, powerful centrifugal squirrel cage with baffle filters, bright 12-volt 20-watt halogen
lights, and heating lamp sockets (lamps not included).
The four electronic controls are Light Control, Speed Control A, Speed Control B and the Power Control
(On/Off). Refer to Figure 18.
Figure 18
TURN ON:
• Press Power Control (On/Off) button once.
(Note: If any Control button is not pressed within 10 seconds, power will be automatically
turned off).
• The KOBE hood will start on Low speed. Each press of the Speed Control button will
cycle through the various speeds.
• Press Speed Control A button to cycle from Low, QuietMode     , High, or Medium.
Press Speed Control B button to cycle from Low, Medium, High or QuietMode     .
(Note: Speed Control A or B will operate both fans. These two speed buttons will allow you
to change the speed quicker.)
• Press Light Control button to turn halogen light on. The light has three settings: High,
Low and Off
• Press the back Red button to turn on heating lamp.
(Note: Heating lamps are sold separately. Heating lamps required 120-volt, 175-watt.)
TURN OFF:
• Press Power Control (On/Off) button once, panel lights will flash and power will be
completely shut off after 3 minutes.
OR
• Press Power Control (On/Off) button twice, all power will be shut off immediately.
• If only the lights are on, pressing Power Control (On/Off) button once will turn power
off after 30 seconds.
Speed Control A
Power Control
Speed Control B
Light Control