Kodak EasyShare C340 - Manual (Page 53)

Troubleshooting
www.kodak.com/go/support 47
Picture quality problems
If... Try one or more of the following
Picture is too dark
or underexposed ■ Reposition camera for more available light.
■ Use Fill flash ( page 27 ) or change your position so light is not behind
the subject.
■ Move so that the distance between you and the subject is within the
effective flash range (
page 9 ).
■ To automatically set exposure and focus, press the Shutter button
halfway. When the Ready light glows green, press the Shutter
button completely down to take the picture.
■ Adjust the exposure compensation ( page 30 ).
Picture is too light ■ Reposition camera to reduce the amount of available light.
■ Turn flash off ( page 27 ).
■ Move so that the distance between you and the subject is within the
effective flash range (
page 9 ).
■ To automatically set exposure and focus, press the Shutter button
halfway. When the Ready light glows green, press the Shutter
button completely down to take the picture.
■ Use Auto, Landscape, or Close-up to adjust the exposure
compensation.
Picture is not clear ■ To automatically set exposure and focus, press the Shutter button
halfway. When the Ready light glows green, press the Shutter
button completely down to take the picture.
■ Clean the lens ( page 60 ).
■ Make sure camera is not in Close-up mode if you are more than
27.6 in. (70 cm) from your subject.
■ Place the camera on a flat, steady surface or use a tripod, especially
in high-zoom settings or in low light.