Kidde KN-COB-B - Manual (Page 4)

Quick Set Up
Remove the three enclosed AA batteries and install them into
the battery well. Carefully place the red battery warning flags into
the battery well. Observe the battery polarity markings at the
bottom of the battery well. After approximately 30 seconds, your
CO alarm will begin monitoring for CO.
Your Kidde CO Alarm is now operational.
Installation Instructions
Installation Location
When choosing your installation locations, make sure you can hear the
alarm from all sleeping areas. If you install only one carbon monoxide
alarm in your home, install the alarm near bedrooms, not in the basement
or furnace room.
• If you have only one alarm, place it near sleeping areas.
• Position near fuel burning appliances, near fireplaces, furnace
or hot water heater.
Recommended Locations
Upper Levels of Home
Basement Levels of Home
DINING KITCHEN BEDROOM BEDROOM
BEDROOM LIVING ROOM
FURNACE
ROOM
6 7