Kenwood KDC-519 - Manual (Page 29)

— 29 —
If the following situations, consult your nearest service
center:
• Even though the disc changer is connected, the Disc Changer source is
not ON, with "AUX" showing in the display during the Changer Mode.
• Even though no device (KCA-S210A, CA-C1AX, KDC-CPS87, KDC-CX87,
KDC-CPS85, KDC-CX85, KDC-CPS82 or KDC-CX82) is connected, the
Auxiliary input is entered when switching modes.
The messages shown below display your systems
condition.
Eject: No disc magazine has been loaded in the changer.
The disc magazine is not completely loaded.
E01
➪ Load the disc magazine properly.
No CD in the unit.
➪ Insert the CD.
No Disc: No disc has been loaded in the disc magazine. E02
➪ Load a disc into the disc magazine.
TOC Error: No disc has been loaded in the disc magazine. E04
➪ Load a disc into the disc magazine.
The CD is quite dirty. The CD is upside-down. The CD
is scratched a lot.
➪ Clean the CD and load it correctly.
Blank DISC: Nothing has been recorded on the MD. E10
No Tr DISC: No tracks are recorded on the MD, although it has a
title.
E11
NO PANEL: The faceplate of the slave unit being connected to
this unit has been removed.
E30
➪ Replace it.
E-77: The unit is malfunctioning for some reason. E77
➪ Press the reset button on the unit. If the "E-77"
code does not disappear, consult your nearest
service center.
Mecha Error: Something is wrong with the disc magazine. Or the
unit is malfunctioning for some reason. E99
➪ Check the disc magazine. And then press the reset
button on the unit. If the "Mecha Error" code does
not disappear, consult your nearest service center.
Hold Error: The protective circuit in the unit activates when the
temperature inside the automatic disc changer
exceeds 60°C (140°F), stopping all operation.
E0d
➪ Cool down the unit by opening the windows or
turning on the air conditioner. As the temperature
falls below 60°C (140°F), the disc will start playing
again.
NO NAME: Attempted to display DNPS during the CD play having
no disc names preset.
E51
NO TITLE: Attempted to display the disc title or track title while
the MD having no MD title is being played.
E53
NO TEXT: • Attempted to display the disc text or track text
while the CD having no CD text is being played. E54
• Attempted to display text during reception of the
station that isn't sending text data. E55
Load: Discs are being exchanged in the Disc changer. E57
NO ACCESS: After setting it in the Disc Changer, DNPP was done
without having it been played at least 1 time. E58
IN (Blink): The CD player section is not operating properly. E59
KDC-519_U.S (K) r4 01.10.19 0:14 PM Page 29