Reinstall bottom vent, Complete installation, Wiringdiagrams – KITCHENAID Cooktop User Manual

Page 13: Wiring diagrams

Advertising
background image

13

3. Press ENTER and default temperature appears in the display.

4. Press ENTER and the default cook time appears in the

display.

Set the cook time to 10 minutes.

5. The display will indicate “LoAd.” Open and close the oven

door.

6. After the 10 minutes counts down, open the oven door. The

cavity should be warm and moist.

7. Press CANCEL and turn the oven selector and RESET.

If oven does not operate:

Check that power supply is turned on.

Check that the range is plugged in and the circuit breaker has
not tripped or the household fuse blown.

Repeat start-up. If the oven still does not operate at this point,
contact your dealer or authorized service company for
assistance.

Install Burner Grates

Place burner grates over burner caps. The simmer plate may sit
on one of the grates or be stored for future use.

Reinstall Bottom Vent

1. Insert lower vent tabs into the slots on the front trim.

2. Push vent upward until the holes line up at top of vent.

3. Reattach the vent using the 4 screws.

Complete Installation

1. Check that all parts are now installed. If there is an extra part,

go back through the steps to see which step was skipped.

2. Check that range is correctly positioned in countertop cutout

and that the range is level. See “Level Range.”

3. Check that the specified distances to cabinet surfaces were

maintained. See “Location Requirements.”

4. Check that burner caps are positioned properly on sealed

burner bases.

5. Check that backguard or island trim is installed. (If horizontal

clearance to combustible materials behind cooking surface is
less than 1" [2.5 cm]).

6. Check that the range is connected only to the type of gas for

which it is certified for use.

7. Use a mild solution of liquid household cleaner and warm

water to remove waxy residue caused by protective shipping
material. Dry thoroughly with a soft cloth. For more
information, see the “Range Care” section of the Use and
Care Guide.

8. Read “Range Use” in the range Use and Care Guide.

9. Turn on surface burners and oven. See your Use and Care

Guide for specific instruction on range operation.

10. Once the oven has cooled down, you may drain the water

reservoir. Read “Water Reservoir Drain Operation” in the Use
and Care Guide.

If range does not operate, check the following:

Household fuse has not blown or circuit breaker has not
tripped.

Gas valves are turned to the “ON” position.

Electrical supply is connected.

See “Troubleshooting” in the Use and Care Guide.

WIRING DIAGRAMS

CAUTION: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation.

Cooktop Schematic

30" (76.2 cm) model

36" (91.4 cm) model

A. Bottom vent
B. Reattach these screws

A

B

L1

L2

N

R

GND

G

BK

W

Y or BR
(4) PLCS

VALVE SWITCHES

SPARK MODULE

IGNITER ELECTRODES

W

R

W

L1

BK

R

GND

G

W

W

W

W

W

N

L2

R

SPARK
MODULE

VALVE SWITCHES

Y OR BR (6) PLCS

IGNITER ELECTRODES

Advertising