Kawasaki POWER WHEELS P5066 - Manual (Page 10)

10 P5066a-0920
Plate
• While holding the handlebar in place, carefully turn the
vehicle over.
• Again, make sure the end of the steering column is through
the hole in the steering linkage.
• Fit the steering column cap onto the end of the steering column.
• Insert a #8 x
3 /
4
" screw through the large opening in the steering
column cap and into the hole in the steering column. Tighten
the screw.
8
• Slide the plate under the steering column, as shown.
• Insert a #8 x
3 /
4
" screw into the plate and tighten.
6
7
• Lift the front end of the vehicle up slightly. Check to be sure
the steering column fits through the hole in the steering
linkage. Lower the front end of the vehicle.
BOTTOM VIEW
Steering Column Cap
Steering Column
• Slide a 7 /
16
" washer onto the front axle.
• Slide a bushing, ring end first, onto the front axle.
• Locate a front wheel. Slide the wheel, flat side first, onto the
front axle.
• Slide a wheel cover, indented side out, onto the front axle.
• Repeat this procedure on the other side of the vehicle.
Front Axle
Washer
Bushing
(Ring End First)
Front Wheel
(Flat Side First)
Wheel Cover
(Indented Side Out)
9