Kompernass KH 150 SE - Manual (Page 10)

 GB/IE
Before the First Usage
First steps
• Carefully remove the slicer from its packaging,
remove all packaging materials and keep them
together with the main packaging.
• Clean the slicer before it comes into contact
with any foodstuffs (see also the chapter
‘Cleaning’).
Setting up the appliance
m Specific safety advice on the placing
of the appliance
1. Never set the slicer up on a hot surface or
near an open flame.
2. Ensure that the power cable does not pass
over hot or sharp-edged objects.
3. Do not allow the power cable to become
kinked or trapped and do not wrap it around
the slicer.
• Set the slicer up on a flat, non-slip surface
close to a power socket.
• Unwind the required length of power cable I.
Insert the plug into the power socket.
• Place the food carriage P on the supporting
table with guide slot O. Now press the on
the blade cover Y high standing side down,
so that the holding clamps (on the underside
of the food carriage P) engage. Ensure that
these have correctly engaged, in that you
check the mobility of the food carriage.
Pull to the front for removal of the food car-
riage P from the guide slot O and lift it from
the support table.
• Push the food holder plate { on to the food
carriage.
• Place the catch tray t below the support
table and on the housing such that the sliced
foods can fall in there directly and without
hindrance after being cut.
Adjust the infinite slice-thickness
setting (see Fig. D)
Through variable tightenings of the adjusting
screws r you can determine the movement rate
of the infinite slice-thickness setting w.
• Screw both of the adjusting screws r tight
with the screwdriver e.
• Check, by turning the infinite slice-thickness
control knob w, to see if the desired movement
rate is suitable.
If it is not,
- loosen both adjusting screws r for a lighter
movement rate or
- tighten both adjusting screws r further for
a stiffer movement rate.
Operation
Working advice
m Specific safety advice for slicing and for
the handling of the appliance
1. Never touch the blade when the slicer is in
operation!
There is a risk of grave personal injury!
2. Always use the food carriage P and the food
holder plate {.
(Exception: very large pieces of foodstuff).
Press the pieces of food to be sliced forward
using the food holder {.
3. Use the slicer only for cutting normal household
foods and not for other purposes. Do not use
Before the First Usage / Operation