Krups 872 - Manual (Page 13)

Following this, allow 2 boiler
of clear water to run through the system.
Switch off the appliance.
Allow the appliance to cool down. Insert the
brewing sieve into the brewing head again
and push the “Perfect Froth” onto the steam
nozzle.
(Always check if machine is plugged in and
if machine is in the proper ON position.)
Problem:
Coffee leaking from filter holder.
Cause:
Filter holder not properly inserted.
Filter holder not pushed in far enough.
Internal gasket is dirty, clean gasket.
Gasket without elasticity, replace.
Coffee powder not cleaned off the edge of
the filter holder.
Problem:
Coffee does not come out.
Cause:
n No water in boiler container.
No coffee in filter holder.
Filter clogged up because coffee mixture
is too fine or pressed down too hard.
Problem:
Steam does not come out of steam nozzle.
Cause:
n No water or not enough water in the
boiler container.
l Steam nozzle is clogged (see “Cleaning”).
“Perfect Froth” attachment is clogged
(see “Cleaning the Perfect Froth”).
Problem:
Not enough froth when frothing the milk.
Cause:
n “Perfect Froth” attachment touches the
bottom of the pitcher.
“Perfect Froth” tip (see figure is
clogged (part A) “Cleaning the
Perfect Froth”).
Steam nozzle is clogged (see “Cleaning”).
Not enough water left in boiler to steam
for 45-60 seconds.
Your KRUPS is covered by the
following warranty:
If from date of purchase within one year this
KRUPS product fails to function because of
defects in materials or workmanship,
KRUPS North America will, at its option,
repair or replace the unit without charge,
provided the owner has a proof of date of
purchase.
This warranty will be void if malfunction
was caused by damage to the product by
accident, misuse, use on frequency or
voltage other than marked on the product
and/or described in the instructions, abuse
including tampering, damage in transit, or
use for commercial purposes. This warranty
gives you specific legal rights, and you may
also have other rights which may vary from
state to state.