Kingston Technology 4000 - Manual (Page 4)

Document No. 48000127-001.A04 DataTraveler ® 4000 Page 4 of 27
Setup (Windows Environment)
1. Insert the DT4000 into an available USB port on
your notebook or desktop and wait for Windows
to detect it.
• Windows XP users will receive a ‘Found New
Hardware’ notification as seen in Figure 2.1 .
• Windows Vista/7 users will receive a device
driver notification as seen in Figure 2.2 .
Once the new hardware detection is complete,
Windows will prompt you to begin the initialization
process.
• Windows
XP users can skip step 2 and go to
page 5 – Device Initialization.
• Windows Vista/7 users will see an AutoPlay
window similar to the one in Figure 2.3 .
2. Select the option ‘
Run DT4000_Launcher.exe ’.
If Windows does not AutoPlay, you can browse to
the CD-ROM partition (
Figure 2.4 ) and manually
execute the DT4000_Launcher program. This will
also start the initialization process.
Figure 2.4 – DT4000 Contents
Figure 2.1 – Found New Hardware
(Windows XP)
Figure 2.2 – Device Driver Installation
(Windows Vista/7)
Figure 2.3 – AutoPlay Window
(Windows Vista/7)
( Note: Menu options in the AutoPlay
window may vary depending on what
programs are currently installed on
your computer. AutoRun will start the
initialization process automatically.
)