Kobe Range Hoods CH8036SQ User Manual
Page 5
4
1) If you need to move the cooking range to install the hood, turn off the power for an electric
range at the main electrical box. SHUT OFF THE GAS BEFORE MOVING A GAS
RANGE.
{Fig. 1}
2) Secure mounting screws with plastic anchors (included) to clean wall surface 41” from
cooking surface leaving about 1/8” of the screw sticking out{Fig. 1a}. (Recommended
height from cooking surface to the range hood bottom is 30”. The height of the hood,
without duct cover, is 11 inches.)
{Fig. 1a} {Fig. 1b} {Fig. 1c} {Fig. 1d}
Use plastic adaptor
1/ 8” space
(Adjustable brackets)
for (7”) duct
Opening.
3) Use screwdriver to loosen mounting brackets at the back of the hood, adjust brackets and
tighten screws (Fig. 1b). Align mounting brackets to the 2 screws on wall and hook hood
into place (Fig. 1c). Tear out & dispose of the template. Make sure protective film has been
removed before installing (Fig.1e). CAUTION: MAKE SURE THE HOOD IS SECURE
BEFORE RELEASING.
4) After adjusting the Exhaust Duct Cover to the desired length (14 1/8
”
to 27
½”
), place a short
screw (included) through the oval opening and hole on duct cover. This will secure the duct
cover at the desired length (Fig. 2). Remove left or right pop out square located at the back
of duct cover for wire outlet access.
{Fig. 2}