Kompernass KH 1156 - Manual (Page 6)

- 4 -
Removing Weighed Items
➩ Press the Z/T-Button once w . The scale shows 0
gramme again
➩ Remove the desired amount of material.
The weight value of the removed material appears
in the display as a negative value.
You can repeat this procedure several times.
Setting the Timer
The Timer enables you to set the clock for a specific
period of time, at the end of which a signal tone
sounds. The preset time runs as in a countdown.
➩ Press once on the Clock-Button e .
The bell symbol appears in the display t at the
top left, next to the clock.
➩ Enter the desired time period with the Z/T w
resp. the KG/LB-button r .
You can set the time in 10 second steps. If you hold
the Z/T
w resp. the KG/LB-button r down conti-
nuously, the figures run through faster.
➩ Press the Clock-Button e , to start the count-
down.
You can stop the timer.
➩ Press once on the Clock-Button e , to stop the
Timer.
You can reset the timer.
➩ Press twice on the Clock-Button e , to reset the
Timer.
When the configured time has elapsed, a signal
tone sounds for 60 seconds.
This signal tone can be switched off by pressing the
On/Off-Button
q .
Temperature Display
When the scale is switched on, the display t
shows the temperature in °C at the top right.
Switching the scale off
If you do not weigh anything for ca. 90 seconds,
the automatic power off switches the scale off.
➩ To switch the scale off manually, press the
On/Off-Button q .
Troubleshooting
➩ If the display t shows „Err“, the scale is over-
burdened. Remove material from the scale. Ne-
ver place more than 11 lb on the scale.
➩ If the display shows „Err“ for a short time and
the scale cannot be switched on, the scale is
overburdened. Remove material from the scale
and switch the scale on again. Place less than
11 lb on the scale.
➩ If your scale does not function as expected, re-
place the batteries. Should this not correct the
malfunctioning, please contact the manufacturer.
➩ If the display shows „LO“, the batteries are de-
pleted. Replace the batteries.
Cleaning
ƽ
Attention!
Ensure that liquids cannot enter the scale. Permea-
ting liquids can damage the scale.
Wipe the scale with a soft cloth moistened with mild
soap suds. Do not use abrasive or solvent cleaners.
The bowl can be cleaned in the dishwasher. The
bowl is suitable for use in dishwashers.
IB_KH1156_AV4136_UK 09.04.2008 17:19 Uhr Seite 4