Kunz MR55K - Manual (Page 10)

C. STAR
: Set parking brake on tow vehicle.
Tur on the underside of the gas tank.
Set
Set the th
Start engine and allow engine to warm up.
Set engine tch handle. (The clutch
handle is located at the front of the mower under the engine.)
CAUTION: If the rough cut mower from the
uncut area before attempting to engage the clutch. Inspect the blades for any obstructions
that may prevent blade engagement. Failure to follow these instructions may result in
premature clutch and belt failure or a fire.
Adjust engine speed to full throttle.
D. SHUTTING OFF ROUGH CUT MOWER
WARNING: Shift to neutral and set the parking brake before dismounting the tow vehicle.
Slow the engine speed down and disengage the clutch handle.
Allow engine to cool down for a short time before moving the ignition switch to the off position.
Turn off fuel shut off valve which is located on the underside of the gas tank.
. MOWER OPERATION
DANGER: Keep hands, feet, hair and clothing away from moving parts.
an or replace any safety signs that are not readable or damaged.
ING ENGINE T
WARNING
Attach mower tongue to tow vehicle.
WARNING: Do not start rough cut mower unless it is attached to the tow vehicle.
n on fuel shut off valve which is located
the choke to the desired position.
rottle at approximately half throttle.
speed at about half throttle and engage mower blades clu
Note: Some belt squealing may occur on engagement. This is normal for a manual clutch
engagement design.
mower’s engine dies while in use, remove the
E
CAUTION: Cle
9