Kompernass KH 527 - Manual (Page 12)

- 6 -
Should this not dislodge the soiling, you can separate
the lower plastic part of the mixer jug (with the cutters)
from the the glass part:
➩
Remove the mixer jug from the motor block.
➩
Turn the plastic part ả of the mixer jug so that it
separates itself from the glass part
Ạ.
ƽ
Attention!
Take care with the cutters Ả. They are very sharp.
Risk of injury!
➩
Clean both parts thoroughly in a mild soapy
solution or in a dishwasher.
➩
Replace the plastic part
ả of the mixer jug back
onto the glass part Ạ. Ensure that the sealing
ring ạ is correctly fitted.
ạ
ả
Ạ
Ả
Cleaning the motor block
➩
Use a dry cloth or, at the most, a lightly moistened
one for cleaning the plastic surfaces.
➩
At every cleaning check that the contact switch
in the receptor for the mixer jug is not blocked
by soiling residues. If you cannot dislodge any
blockages with the corner of a piece of paper,
make contact with Customer Services. Under no
circumstances should you use a hard object, this
could damage the contact switch.
➩
Remove any possible residues on the underside
of the motor block only with a dry cloth or a stiff
bristled brush. Ensure that nothing can enter
through the ventilation opening of the appliance.
After cleaning
Allow all parts to dry well before re-assembling and
re-using the liquidiser.
Storage
➩
If you do not intend to use the liquidiser for an
extended period, clean it thoroughly (see chapter
"Cleaning").
➩
Wrap the power cable around the cable storage
on the base of the motor block.
➩
Store the liquidiser at a cool and dry location.
IB_KH527_E2248_LB4 13.12.2007 9:59 Uhr Seite 6