Kenwood TM-V71E - Manual (Page 94)

86
10 Press [REV] + Power ON to enter Remote Control mode.
• The and icons appear on the display.
• To exit Remote Control operation, turn the transceiver power OFF, then press [REV]
+ Power ON again.
CONTROL OPERATION
While in Remote Control mode, the DTMF keys of the handheld will function as
shown in the table below. Each time you press the desired key, the handheld will
automatically enter transmit mode and send the corresponding command to the
mobile.
Note: If using a handheld without a remote control function, manually send “AXXX#YA#” where
“XXX” is a 3-digit secret number and “Y” is a single-digit control command. If you do not add ”A#”
to the end, you can skip sending “AXXX#” next time; however, the mobile may be accidentally
controlled by other stations.
Operation DTMF Command
Access your mobile via the remote unit (where *** is your
3-digit secret number)
A *** #
End access of your mobile via the remote unit A #
DCS ON 1
Tone ON 2
CTCSS ON 3
DCS OFF (all signalling OFF) 4
Tone OFF (all signalling OFF) 5
CTCSS OFF (all signalling OFF) 6
Call mode ON 7
VFO mode ON 8
Memory mode ON 9
Transmit power (press to toggle between High, Medium, and
Low)
0
Frequency (in VFO mode) or Memory channel (in Memory
mode) directy entry
A XXXXXXX
DCS code (when DCS is ON), Tone frequency (when Tone is
ON), or CTCSS frequency (when CTCSS is ON) setup
B XXX
(DCS code)
BA XXX (Tone/
CTCSS frequency
Repeater (Cross-band or Locked-band) ON C
Repeater OFF D
Step the frequency or Memory channel down
Step the frequency or Memory channel up
#