Kenwood KAC-8151D - Manual (Page 6)

6 English
Connection
40
8 9 0 ! @
^ & $ % #
8 Fuse (40 A)
If you can’t find the specified capacity fuse at
your store etc., consult your Kenwood dealer.
9 Battery terminal
0 Ground terminal
! Power control terminal
Controls the unit ON/OFF.
Controls the unit power. Be sure to connect
it with all the systems.
@ Speaker output terminals
As this unit accepts speakers with a
minimum impedance of 1 ohm, connect
speakers with 1-ohm or higher impedance
to these terminals.
The rated input of the speakers should be
no less than the maximum output of the
amplifier. Otherwise malfunction may
result.
# RCA cable ground lead terminal
When using an RCA cable with a ground
lead attached, connect the ground lead to
this terminal.
$ LINE IN terminal
% LINE OUT terminal
The signal that’s input from the line input
terminal is output.
^ REMOTE terminal (KAC-8151D
only)
Connects the Remote cable.
Use the Remote cable of the accessory.
& Speaker level input terminals
• The genuine-accessory car stereo shall
have a maximum power output of no
more than 40 W.
• Do not connect the speaker output leads
from a power amplifier (Optional) to the
speaker level input terminals of this unit,
for this may cause malfunction or
damage.
• Do not connect cables and leads to both
RCA cable input jacks and the speaker
level input terminals simultaneously, for
this may cause malfunction or damage.
• Connect the power control lead to a
power supply which can be turned
ON/OFF by the ignition key switch (ACC
line). With this connection, shock noise
may be generated when the power of the
genuine-accessory car stereo is switched
ON/OFF.
NOTE
NOTE
2CAUTION
NOTE
NOTE
■ Terminal names
KAC-8151D/8101D(KE) 1English 02.11.14 10:42 AM Page 6