Kenwood KAC-8101D - Manual (Page 3)

English 3
Installation
• Do not install in the below locations;
(Unstable location, In a location that interferes with driving, In a location that gets wet, In a
dusty location, In a place that gets hot, In a place that gets direct sunlight, In a location that
gets hit by hot air)
• Do not install the unit under the carpet. Otherwise heat build-up occurs and the unit may be
damaged.
• Install this unit in a location which allows heat to easily dissipate.
Once installed, do not place any object on top of the unit.
• The surface temperature of the amplifier will become hot during use. Install the amplifier in a
place where people, resins, and other substances that are sensitive to heat will not come into
contact with it.
• When making a hole under a seat, inside the trunk, or somewhere else in the vehicle, check
that there is nothing hazardous on the opposite side such as a gasoline tank, brake pipe, or
wiring harness, and be careful not to cause scratches or other damage.
• Do not install near the dashboard, rear tray, or air bag safety parts.
• The installation to the vehicle should securely fasten the unit to a place in which it will not
obstruct driving. If the unit comes off due to a shock and hits a person or safety part, it may
cause injury or an accident.
• After installing the unit, check to make sure that electrical equipment such as the brake lamps,
turn signal lamps and windshield wipers operate normally.
2CAUTION
Installation board, etc.
(thickness : 15 mm or more)
Self-tapping screw
(ш4 Ч 16 mm)
Remote cable
OFF +6 dB
+12
+9
Remote controler
Dressing plate
Nut
Knob
Self-tapping screw
(ш3 Ч 12 mm)
Remote controler (KAC-8151D only)
Double-side tape
Washer
Mount the Dressing plate
according to the mount
angle of the Remote
Controller.
Fully rotate the knob
counterclockwise (CCW), and adjust the
marking of the knob to the "OFF" position of
the Dressing plate.
NOTE
OFF
+6
dB
+12
+9
KAC-8151D/8101D(KE) 1English 02.11.14 10:42 AM Page 3