Kenwood KRF-V7773D User Manual
Kenwood Receivers and Amplifiers
Advertising
Table of contents
Document Outline
- VR-4090_4080_KRF-V7773D
- Table of Contents
- Chapter One: Moving Around
- Chapter Two: Controlling the Receiver
- How Do I Adjust the Sound?
- Turning the Speakers On
- Adjusting the Volume
- Adjusting the Tone (Stereo mode only)
- Adjusting the Loudness (Stereo mode only)
- Adjusting Speaker Levels
- Adjusting the Input Level
- Muting Sound
- Midnight Theater Function (Dolby Digital playback only)
- What are Listen Modes?
- Checking the listen mode during playback
- To set the listen mode manually:
- Examples of inputs with which switching is available
- What are input modes?
- Switching Input modes
- Applying Digital Signal Processor (DSP) Effects
- Setting a DSP effect
- HDCDR and D.R.I.V.E. Effects
- Headphone Operation
- Selecting the Inputs
- How Do I Operate Devices?
- Operating a Television
- Operating an AV Device
- Operating a CD player
- Single or Rotary CD Player
- CD-R Recorder
- Operating an MD Recorder or Cassette Deck
- Playing an Analog Turntable
- Monitoring a Video Camera or Playing an Additional VCR
- Playing a Second CD player or Cassette Deck
- Radio Tuning
- RDS (Radio Data System) for U.K. Only
- To tune into a radio station:
- Storing RDS Station Automatically
- To search for a specific type of music or radio program:
- Recording
- How Do I Adjust the LCD Display?
- Executing Several Operations at Once (Macro function)
- How Do I Adjust the Sound?
- Chapter Three: Key Layout in Controlling Other Devices
- Chapter Four: Troubleshooting
- Sound
- I don’t hear any sound at all
- Audio is not output only when a 96k fs compatible disc is played.
- I can’t hear sound from one or more of the speakers, or the sound is abnormally low.
- I can’t hear sound from my surround or center speakers
- I can hear sound only from the center speaker when Dolby ProLogic or Dolby 3 Stereo is selected
- Sound from one (or more) of my components is abnormally loudor soft
- I can’t hear sound from some of my laser discs
- There wasn’t any sound recorded on tapes made on my VCR or tape deck.
- The initial sound is intermittent or non-existent when I start to play a Dolby Digital, DTS or MPEG source.
- With a Dolby Digital program, the loud sounds aren’t very loud and the quiet sounds aren’t very quiet.
- All I hear is loud static when I play DTS discs
- I hear a hum when I select the PHONO input
- Sound is intermittent
- Video
- Remote Control unit
- Receiver/Tuner
- My receiver won’t turn on and the STANDBY indicator is flashing front panel flashes red continually, or stays red for more than 1 second at a time.
- I can’t receive a radio station
- I can’t access any RDS (Radio Data System) functions
- I’m getting a lot of static/interference
- When I press a key to tune to a preset station, the receiver does not respond
- Sound
- Numerics