Kohler CFI230G - Manual (Page 8)

8 21
Check glass is vertical. If not
remove screws, re-drill and
re-fit as required.
Re-fit rubber strip over
screws
Drill 4 x 3mm holes
through jamb into wall
channel
STEP
10
STEP
11
Fit 4 x screws
B
Ensure glass panel is vertical
STEP
9
Slacken screws ‘A’. Push the glass panel into
the wall jamb. The glass should be 2mm lower
than the top of the wall jamb. Tighten screws ‘A’
when the glass is in the correct position
STEP
13
B
OPERATION
Warm Up Function (Optional)
1. Press the Warm Up push-button.
2. The unit delays turning on to allow you to get out
of the shower.
3. The Warm Up push-button flashes for a number of
seconds until water comes out of the handset at the desired temperature.
4. When the water is at the desired temperature the unit turns off waiting for you to shower.
To Operate the Shower
1. Press the Low, Medium or High flow push-button.
2. Water will come out of the handset at the desired temperature.
3. To alter the showering temperature, turn the temperature control knob. Whilst the showering temperature
stabilises, the selected flow push-button will flash.
4. Press the Off push-button at the end of your shower.
Caution!
Anyone who may have difficulty understanding or operating the controls of any shower should be attended
whilst showering. Particular consideration should be given to:
• the young
• the elderly
• the infirm
• the disabled
• anyone who suffers from a medical condition that can result in temporary incapacity (e.g. epilepsy or
blackouts).
• anyone inexperienced in the correct operation of the controls.
Low, Medium or High Flow Button - Buttons glow BLUE when pressed
Temperature
Control Knob
Warm Up/Off Button
- glows BLUE
when powered
CFI230G CFI230G
Carefully remove the Water Delivery System
from the Water Delivery Wall Jamb.
A
STEP
12