Kenwood DPX502 User Manual
Page 29
English
|
29
Other than Standby mode
Audio Preset Recall
Recalling the sound setup registered by <Audio
Preset Memory> (page 28).
1
Select the source
Press the [SRC] button.
2
Enter Menu mode
Press the [MENU] button for at least 1 second.
"MENU" is displayed.
3
Select Audio Preset mode
Push the Control knob towards up or down.
Select the "A-PRESET" display.
4
Enter Audio Preset mode
Press the Control knob for at least 1 second.
5
Select the Audio Preset Recall
Push the Control knob towards up or down.
Select the "RECALL" display.
6
Recall the Audio Preset
Press the Control knob for at least 2 seconds.
The "RECALL" display blinks 1 time.
7
Exit Audio Preset mode
Press the [MENU] button.
⁄
• The User memory of <System Q> (page 8) is changed to
the value which was recalled.
• The source tone memory item of <Audio Control> (page
8) is changed to the value which was recalled by the
selected source.
In Standby mode
Firmware version display
Displaying the firmware version with the unit.
1
Select the firmware version display mode
Push the Control knob towards up or down.
Select the "F/W VER" display.
2
Display the firmware version
Push the Control knob towards right or left.
In Standby mode
Demonstration mode Setting
Sets the demonstration mode.
1
Select the Demonstration mode
Push the Control knob towards up or down.
Select the "DEMO" display.
2
Set the Demonstration mode
Press the Control knob for at least 2 seconds.
Each time you press the knob at least 2 seconds,
the Demonstration mode alternates between the
settings shown in the table below.
Display
Setting
"DEMO ON"
The Demonstration mode function is ON.
"DEMO OFF"
Exit Demonstration mode (Normal mode).