Kicker KX2500.1 - Manual (Page 14)

MODEL: KX2500.1
14
KX2500.1 Amplifier
Specifica
tions
1 x 1500
1 x 2500
1 x 1200
1 x 2000
Height:
Width:
Length with EndKaps:
Length without EndKaps:
Frequency Response:
Input Sensitivity:
Signal-to-Noise Ratio:
Electronic Crossover:
KickBass Boost:
Subsonic Filter:
@ 14.4Vdc, 4
Ω
Mono, 1.5% THD+N
@ 2
Ω
Mono, 1.5% THD+N
@ 12.5Vdc, 4
Ω
Mono, 1.5% THD+N
@ 2
Ω
Mono, 1.5% THD+N
2-1/2 inches / 6.35 centimeters
10-1/8 inches / 25.7 centimeters
30-9/16 inches (77.6cm)
26-5/16 inches (66.8cm)
20 Hz - 200Hz, +0, -1 dB
170 mV - 5 V low level, 340 mV - 10 V high level
>85 dB, a-weighted, re: rated power
Variable low pass, 50 - 200 Hz, 12 dB/octave
Variable 0 to +18 dB boost @ 40 Hz
12 dB/octave High Pass @ 25 Hz
RMS POWER
In Watts, All Channels Driven
NOTE: All specifications and performance figures are subject to change. Please visit the support section at www.kicker.com for the most current information.
Power Wire Chart
Kicker Recommended
For Maximum Performance
Amperage
Draw
Up to
5 ft.
5 to
10 ft.
10 to
15 ft. 15 to
20 ft. 20 to
25 ft.
0-20
20-35
35-50
50-65
65-85
85-105
105-125
125-150
150-200
200-250
250-300
8 Ga. 8 Ga. 8 Ga. 8 Ga. 4 Ga.
8 Ga. 8 Ga. 8 Ga. 4 Ga. 4 Ga.
8 Ga. 8 Ga. 4 Ga. 4 Ga. 4 Ga.
8 Ga. 4 Ga. 4 Ga. 4 Ga. 1/0 Ga.
4 Ga. 4 Ga. 4 Ga. 1/0 Ga. 1/0 Ga.
4 Ga. 4 Ga. 1/0 Ga. 1/0 Ga. 1/0 Ga.
4 Ga. 1/0 Ga. 1/0 Ga. 1/0 Ga. 1/0 Ga.
1/0 Ga. 1/0Ga. 1/0 Ga. 1/0 Ga. 1/0 Ga.
1/0 Ga. 1/0 Ga. 1/0 Ga. 1/0 Ga. 1/0 Ga.
x 2
1/0 Ga. 1/0 Ga. 1/0 Ga. 1/0 Ga.
x 2
1/0 Ga.
x 2
1/0 Ga. 1/0 Ga. 1/0 Ga.
x 2
1/0 Ga.
x 2
1/0 Ga.
x 2
* For current draw exceeding 300 amps or cable lengths in excess
of 25 feet contact Kicker or your local Kicker dealer for advice.
Performance
1500 x 1 @ 4 ohms, from 20-200 Hz, 14.4Vdc, 1% THD
CEA-2006 (Watts)
Signal to Noise Ratio -46
CEA-2006 (ref: 1W, A-weighted)